Go Back
+ servings
buffalo check grapevine pumpkin wreath
Print Recipe
5 from 1 vote

DIY Buffalo Check Pumpkin Fall Wreath

an easy DIY buffalo check farmhouse fall wreath
Total Time30 minutes
Servings: 1 wreath
Author: Stephy
Cost: $20

Equipment

  • hot glue gun
  • sharp scissors
  • floral wire
  • floral wire cutters
  • tape measure

Ingredients

  • 1 wire pumpkin wreath form
  • 1 15 ft grapevine garland
  • 2 cotton stem stalks
  • 3 buffalo check and white pumpkins
  • 2 large burlap leaves
  • twine
  • 1 buffalo check ribbon

Instructions

  • Wrap grapevine garland around the exterior outline of the wreath, attaching it to the wreath form with floral wire as you go. Skip the stem.
  • Measure the length of each interior wire (as they vary in size) and cut out the appropriate sizes of grapevine garland.
  • Attach the pieces of garland to the insides of the wreath form with the floral wire. The whole pumpkin should be covered in grapevine now.
  • Wrap twine around the stem of the pumpkin and glue the ends with hot glue.
  • Add a buffalo check bow below the stem in the center by attaching it with floral wire.
  • Glue two burlap leaves to each side of the top of the pumpkin.
  • Add one cotton stalk to each side of the bottom of pumpkin form using floral fire to secure it in place.
  • Add any extra accents you want on the bottom (bows, ribbons, fall picks, fall leaves, etc).
  • Finally, glue the pumpkins where you want them.